My wife parked the RAV for 1 hour at the dentist.
When she came back, there was this dent :wall
She was facing a wall with a path in between the RAV and the wall. Seems like someone might have stumbled and taken support on the fender on the driver side.
I got a dent puller but I am not sure which technique will give the best results.
1. Moisten the surface of the fender and use the dent puller, starting from the middle where the create is deepest?
2. pull out the fender liner and push with my hands, starting furthest from the crease?
I actually have 2 dents,
.first is wide and shallow
.the other is deeper and about 2 inches long.
I think I might even have to use a hammer to attack the vent from below. This had to happen when it's start getting cold outside!
I welcome your suggestions.
When she came back, there was this dent :wall
She was facing a wall with a path in between the RAV and the wall. Seems like someone might have stumbled and taken support on the fender on the driver side.
I got a dent puller but I am not sure which technique will give the best results.
1. Moisten the surface of the fender and use the dent puller, starting from the middle where the create is deepest?
2. pull out the fender liner and push with my hands, starting furthest from the crease?
I actually have 2 dents,
.first is wide and shallow
.the other is deeper and about 2 inches long.
I think I might even have to use a hammer to attack the vent from below. This had to happen when it's start getting cold outside!
I welcome your suggestions.