Toyota RAV4 Forums banner
1 - 1 of 1 Posts

· Registered
2013 RAV4 XLE Plus
Joined
·
356 Posts
Unfortunately there's no relay from 2013 to present, its all in the computer now. I have LEDs on the front, I used Sylvania Zevo, they use quite a bit current plus I have a Switchback halo in each headlight housing. I played with a bunch of resistors and found that an 18 ohm resistor gets rid of the hyper flashing. So i ordered some 18 ohm 25 watt resistors. They don't get hot and the system works perfect but keep in mind that I have the replacement LED and a halo around the headlight projector. I believe the current draw was around 1.85 amps when combined
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top