Toyota RAV4 Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
When I tried to close one of conditioner gateway in my RAV4 2016
Cannot close it because there are sponge in front of gateway prevent close the gateway and when I blows air from my mouth into gateway after turned off the conditioner, the sponge went into back and gateway closed.
But when turned on the air conditioner, the sponge come into front again.

What to do?

From where this sponge comes?
 

· Registered
Joined
·
38 Posts
When I tried to close one of conditioner gateway in my RAV4 2016
Cannot close it because there are sponge in front of gateway prevent close the gateway and when I blows air from my mouth into gateway after turned off the conditioner, the sponge went into back and gateway closed.
But when turned on the air conditioner, the sponge come into front again.

What to do?

From where this sponge comes?
There is some spongy material for the duct work meets the vent that's probably what is bad
 

· Registered
Joined
·
239 Posts
Which vent is this happening in? I think the outer trim/flow directors just clip in so using a trim removal tool and plenty of care you should be able to pop it out. This allows you to fix the foam and then reinstall. I can't remember for sure but I think the inner vents by the head unit are similar, clipped in.

Sent from my SM-G950W using Tapatalk
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top