Toyota RAV4 Forums banner
1 - 1 of 1 Posts

· Registered
780 Posts
Discussion Starter · #1 ·
The following information is intended to clarify the repair manual procedures for Zero Point Calibration and sensor checks after the replacement of any of the following components;

*Vehicle Stability Control Computer
*Steering Angle Sensor
*Yaw Rate Sensor
*Deceleration Sensor

Previous versions of this TSB should be discarded


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.