Joined
·
26 Posts
while under my 97 2-door 4WD I noticed the two pieces of the two piece drive shaft are not aligned. There is a center support. The piece going from the rear of the transaxle to the center support is not aligned with the piece going from the center support to the rear differential.
I had the engine out of the car recently and the entire drive shaft was removed but I don't recall an adjustment in the center support area.
Anyone with any knowledge in this area? Thanks.
I had the engine out of the car recently and the entire drive shaft was removed but I don't recall an adjustment in the center support area.
Anyone with any knowledge in this area? Thanks.