Toyota RAV4 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi. New to the forum.
I'm nearing the end of a 1998 MT 4WD Clutch replacement. I've gotten to the point where I'm a bit confused over the routing of the engine wire on the transaxle (driver) side of the engine. Looks like there are at least two bolt supports. I think I found one, but could use a definitive location for both.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #2
Figured it out. One of the connection points goes to a stud attached to a water line close to the engine, which had a sufficient sized nut on it. The other goes to the starter bolt hole (the sort of hidden one). Makes good sense now!!
 
1 - 2 of 2 Posts
Top