[jdmtai]

I need some help converting this 6v camera to work with a 12v unit. ive been reading a around but still a little confused. anyone got a diagram to run it? have anyone used the 12v stepdown to 6v convert? it comes with 2 black wire and one yellow and one red.

 

[JuneBug]

What you need is a 12 volt to 6 volt DC-DC converter. Here's one on Ebay for less than 5 bucks:

12V to 6V DC DC Buck Converter Step Down Module Power Supply Volt Regulator WD | eBay

 

[jdmtai]

What you need is a 12 volt to 6 volt DC-DC converter. Here's one on Ebay for less than 5 bucks:

12V to 6V DC DC Buck Converter Step Down Module Power Supply Volt Regulator WD | eBay

yeah I know that part. need a diagram to hook it up to the wires if anyone knows or steps to do it

 

[bionictony]

how do you know the factory backup camera operates at 6v?

 

[czgu]

yeah I know that part. need a diagram to hook it up to the wires if anyone knows or steps to do it

From the picture, IN(PUT) R (red) + and B (black) - connect to 12V, OUT(PUT) Y (yellow) + and B (Black) - output 6V/3A max.

 

[jdmtai]

From the picture, IN(PUT) R (red) + and B (black) - connect to 12V, OUT(PUT) Y (yellow) + and B (Black) - output 6V/3A max.

still confused lol don't I need a rca wire

 

[jdmtai]

i know someone nows how to retain back up camera with aftermarket unit. help me out lol

 

[markga1]

Do a search for (aftermarket nav install) in this thread. There are a couple of quite extensive posts. Hope this helps.

http://www.rav4world.com/forums/124-4-4-interior/140849-aftermarket-nav-swap-5.html. this should help esp the last post on page 5

good luck