[BROX]

Steering is a bit lumpy for the first couple of minutes from cold,then its fine.I suspect the belt is slipping a bit on fast idle on start up.(fluid changed a while back)

Had a quick look this morning ,looks a bit tight for space(getting at the 2 bolts etc),any tips on changing the belt please. (i will do both as the alternator belts needs to come off anyway)....Thanks

 

[BROX]

Thanks Ken....i was thinking the process was something like that,i'll give it a go soon.....the p/s belt feels very soft and spongy,i think its been there a long time.

Luckily i replaced all the bottom cover bolts with stainless steel bolts and washers (and grease)....and drilled out and re tapped the broken ones.

 

[BROX]

It cost me approx £3 to replace the under cover tray bolts with stainless steel allen head M6 X 25mm bolts and washers along with a good covering of grease on each....its a nice tidy looking job,the covers were mostly held on with cable ties before i got it.

 

[BROX]

All done...not too bad,wouldn't want to do it too often though.