Toyota RAV4 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
..bought a '99..not happy with look of the fender flares and the additional width..parts dept diagram shows that when the cladding for the flares comes off it will leave visible bracket mounting holes....any ideas how to cover these without adding much width to car? thx
 

·
Premium Member
'99 RAV4.1, 3MZ-FE, E250F 4x4, Torsen Dif
Joined
·
2,163 Posts
I haven't taken the rear ones off, but the front ones on my 99 RAV 4 door didn't have any exposed bolt holes unless you looked under the wheel well. The mounting brackets were severely corroded, fortunately it didn't spread to the body. Replacing the bracket with a strip of aluminum and self taping stainless steel screws.
 
1 - 2 of 2 Posts
Top