Toyota RAV4 Forums banner

Sailfin tweeters

Jump to Latest Follow

1 - 1 of 1 Posts
O

·
Guest
Joined
·
0 Posts
Discussion Starter • #1 •
Hey all -

Has anyone attempted to get factory sailfin tweeters and the shroud to install on a Canadian RAV4? If so, where did you get them? Haven't had the door panels off yet; is the factory wiring in place for adding the tweeters as in US models or will I have to tie in to the primary speaker wire?

Thanks for any help.
 
1 - 1 of 1 Posts
Recommended Reading
Read More

  1. Rav4.2 OEM HID

    4.2 D.I.Y. and Modifications
    Well, look at what i've found: Didn't realize that these cars came with what looks like OEM HID's but also headlight levelling. You can see the ballast at the bottom of the headlight. Anybody have any experience finding a set of these from Japan? they're awfully expensive from what i've read...

  2. 3SGTE Swap, 2AZ supercharger, or 2AZ turbocharger

    4.2 D.I.Y. and Modifications
    Hey guys. I’m hoping to do some modifications. I’m hoping to get the best bang for my buck, so I’m trying to decide whether I should do a 3SGTE swap, supercharge the stock 2AZ or turbocharge the stock 2AZ. What does everyone think?

  3. Lifted Rav4 Build Thread

    4.2 D.I.Y. and Modifications
    Hello all, This post is a place saver for a detailed build thread with pictures of my Rav4 lifted on Old Man Emu Springs and the 30mm Tema 4x4 lift kit. The attached picture is with 235/60/16 tires. Many more details to come. -Grathlong

  5. Suspension overhaul

    4.2 D.I.Y. and Modifications
    At 180k miles, it's probably high time I do something with the original suspension components. Especially since I don't plan on parting ways with the Rav for quite a while. If / When it dies, a 2.4 L 2AZ-FE swap is being considered. With that said, here is the list of replacement parts I have...

  6. 2005 RAV4 Fog Light Housing Replacement

    4.2 D.I.Y. and Modifications
    Can anyone provide any details on the removal of the fog light housing? It appears to fit into a moulded plastic section which is part of the bumper. There are plastic tabs on the housing which fit into the moulded plastic. There is an adjustment screw on the bottom of the fixture but I cannot...
Read More
About this Discussion
0 Replies
0 Participants
Last post:
Oilman65
Toyota RAV4 Forums
Rav 4 World is the internet's largest Toyota Rav4 SUV and EV online forum community. Discuss towing, modifications, and more.
Full Forum Listing
Explore Our Forums
4.3 General 4.3 Mechanical 4.3 Exterior 4.3 Interior 4.4 General
Popular Communities
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Home Improvement
Home Improvement
290,000+ members
Join
Top