Toyota RAV4 Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I'm planning on installing an Alpine PWE-S8 under my passenger seat this week. I still have the stock HU, but an Alpine 445U 45 W RMS amp and all Alpine speakers. I plan to tap into the rear speaker leads behind the HU. So my question is around how best to set all the filter. If I give the sub everything about 100 Hz and below, I can set the amp/sub LP filter to 100. If I set the 445U HP filter to 100 Hz, there won't be any signal for the amp/sub to pick up, but then I'm still sending the low frequency to the alpine speakers and muddling their response. Should the front speakers HP be set to 100? Insight?

Thanks
 
1 - 1 of 1 Posts
Top