So here's the full story.
I was trying to program a new TPMS sensor. I got a cheap xhorse cable from amazon and was using Techstream to program the dang thing. It didn't work. I kept throwing an error stating "is registration failed due to a communication error with the WCU while in Initialization mode" and "terminate initialization by connecting tc and cg of the dlc3 for 30 seconds"
So I tried to terminate those and it wasn't working. So I then, tried to terminate other pins nearby incase I got it wrong. Yes I know that was stupid of me. Now my car has the ABS, Brake and VSC light on. Also when I pull the codes in Techstream, it has a C1203 code. When I try to clear the code it doesn't clear and it just stays.
So, I was wondering if you guys know what I can do to fix this. I seen some guy on youtube did a "Zero Point calibration"?
Do you think this might help?
Could I have damaged my ECU by poking the wrong obd2 connector pins?
I was trying to program a new TPMS sensor. I got a cheap xhorse cable from amazon and was using Techstream to program the dang thing. It didn't work. I kept throwing an error stating "is registration failed due to a communication error with the WCU while in Initialization mode" and "terminate initialization by connecting tc and cg of the dlc3 for 30 seconds"
So I tried to terminate those and it wasn't working. So I then, tried to terminate other pins nearby incase I got it wrong. Yes I know that was stupid of me. Now my car has the ABS, Brake and VSC light on. Also when I pull the codes in Techstream, it has a C1203 code. When I try to clear the code it doesn't clear and it just stays.
So, I was wondering if you guys know what I can do to fix this. I seen some guy on youtube did a "Zero Point calibration"?
Do you think this might help?
Could I have damaged my ECU by poking the wrong obd2 connector pins?