See the video at
www.youtube.com/watch?v=TbOr7gvqSqc , about 37:25 and then again around 1:33:50
Time stamps for the video:
03:00 Work Begins.
03:30 Remove battery & tray
04:10 Remove Spark Plugs Wires and Spark Plugs
06:01 Remove Power Steering Reservoir
06:16 Remove Alternator
09:18 Remove Alternator Bracket
09:59 Drain Coolant
10:58 Remove Front Tire
11:12 Lift Points
12:53 Remove Power Steering Belt
14:18 Remove Harmonic Balancer Bolt
20:20 Remove Harmonic Balancer
23:35 Location of Crankshaft Position Sensor
23:45 Remove Engine Insulator and Engine Mount Bracket
35:47 Remove Top Timing Cover
37:25 Alignment of Timing Marks before Removal of Lower Timing Cover
42:27 Remove Lower Timing Cover
43:46 Remove Old Timing Belt
45:05 Remove Tensioner Pulley
46:01 Remove Idler Pulley
46:40 Explaining the Belt Guide Washer -- this washer goes OVER the bell (there is no belt in place when I explain the washer)
47:00 Remove Crankshaft Sprocket
47:39 Crankshaft Position Sensor
48:01 Remove Oil Pump Drive Housing
49:07 Remove Oil Pump Sprocket
49:38 Remove and Replace Oil Pump Seal & Gasket
53:23 Install Oil Pump Drive Housing
55:58 Remove Camshaft Sprocket
58:14 Remove Camshaft Seal
1:01:33 Install Camshaft Seal
1:05:21 Install Camshaft Sprocket
1:06:34 Remove Crankshaft Seal
1:08:31 Install Crankshaft Seal
1:10:30 Remove Water Pump (begins)
1:11:42 Remove Thermostat
1:16:17 Install Water Pump
1:21:14 Install Thermostat
1:21:53 Install Tensioner Pulley
1:23:42 Install Idler Pulley
1:24:05 Replace Timing Cover Gasket
1:24:40 Install New Timing Belt
*
Important: I forgot to mention it, but you’ll see the guide washer installed at 1:33:19. Make sure you install the guide washer AFTER installing the belt, but BEFORE installing the Lower Timing Cover *
1:33:19 Install Lower Timing Cover – Remember to install Guide Washer first
1:33:42 Install Harmonic Balancer
1:33:50 Belt Tensioning Procedure (1 and 7/8 Turn Method)
1:34:35 Torque down Tensioner Pulley Bolt (at 45 BTDC)
1:34:54 Install Top Timing Cover and Engine Mount Bracket
1:37:58 Install Engine Insulator (Mount)
1:44:28 Install Harmonic Balancer Bolt
1:46:01 ABS Bracket Install
1:46:50 Reposition Power Steering Reservoir
1:46:57 Install Alternator Bracket
1:47:53 Install Alternator
1:49:24 Install Power Steering Belt
1:51:58 Install Alternator Belt
1:55:09 Install Fender Liner & Wheel
1:55:22 Install Spark Plugs and Wires
1:57:29 Install Battery Tray and Battery
1:58:25 Refill Coolant
2:01:14 Bleed Coolant
