[JuneBug]

Bummer. Does the window motor "grunt" a little when it gets near the top and contacts the full width of the added visors plastic?
On my 2010 F150 it did...$300 motor and cable assembly.....pretty common/crappy ford thing.

Mine don't. I've had the Weathertech in channel visors installed on all 4 of my doors for almost 6 years with no problems. Only on the first day did the driver's window anti-pinch system reverse when it contacted the visor at the top. After keeping the window up for 24 hours as the instructions recommended, that never happened again. I highly recommend them. I've seen too many of the stick-on type fall off or crack.

http://www.rav4world.com/forums/97-.../97-4-3-exterior/78779-installed-weathertech-side-window-visors.html#post812589

 

[JuneBug]

Yes, this thread is for the 4.3, but it's the same engine and same oil change procedure:

http://www.rav4world.com/forums/106...-2-5-liter-i-4-2ar-fe-oil-change-instructions-new-4-cylinder-engine-2009-a.html

 

[JuneBug]

What is the correct torque value for the oil pan drain bolt? Thanks

Cut and pasted from the thread I referenced above:

Clean and install a new gasket and the oil pan drain plug.

Torque: 40 N·m (408 kgf·cm, 30 ft·lbf)