Toyota RAV4 Forums banner

Under-engine Splash Guard falling off

688 views 5 replies 4 participants last post by  Merlin820  
#1 ·
Hi all! I'm new here and actually working on my wife's vehicle.

On her 2008 RAV4, the large plastic cover piece is coming loose and dragging on the road. I'm looking to identify the right fasteners I need to keep it attached.

Part of my struggle is that I don't know what the formal name of the part is. I've seen "splash guard" in my initial googling. I'm not seeing an obvious part number on it when I have been underneath the car, and I don't really want to take it all off from the front bumper. I found a possible match on Amazon (can't include link on my first post, item title is "Parts N Go 2006-2012 RAV4 Engine Under Cover Lower Splash Guard - 5141042050 TO1228143") but I'm not sure if that's right

I may decide to replace the whole cover, but before that I'm looking for a good source for the correct screws and clips I need to hold the thing on (inexpensive is nice, I don't mind replacing cheap plastic once I know what the right clip is), and optimistically hoping for a diagram/repair manual that tells me which holes are for screws and which are for clips.

Thanks!
 
#2 ·
Those fasteners are push - expand for installation, pull - contract for removal plastic push rivets. I had to replace a few and got what I needed at our Ace Hardware, cost about 50 cents each. Better than the OEM Toyota fasteners. There are no screws or holes for them holding our splash guard - only holes for the rivets.
 
#5 · (Edited)
The cover you've listed is the correct part number 51410-42050, also known as Engine Under Cover Assembly #1. Majority of the clips will be 90467-07215, if you search on Amazon for that part number, third parties have ones that will work, and this was what I had recently bought.
Image